Fujitsu D2264 Motherboard

Specification

• AMD Athlon/AMD Sempron
  • AMD939 Socket
• SiS 761Chipset
• FSB 2000MHz
• 4 DIMM Slots (DDR2) - dual channel
  • 2.6V, DDR2
  • Max memory 4GB
  • No ECC Support
• Integrated SiS761 Video Controller
  • up to 128MB shared memory
• Onboard RAID support (driver on DUCD) - see RAID configuration pages for more information
• Integrated AC97 Audio Codec (Realtek ALC655)
  • 1 x Line In
  • 1 x Line Out
  • 1 x Microphone
• Slots
  • 1 PCIe x16
  • 1 PCIe x1
  • 2 PCI
• Integrated LAN - Realtek RTL8110 (10/100/1000mbps)
• SATA Controller (no IDE support for hard drives)
  • supports up to 2 SATA drives (150MB/s)
• Supports up to 8 USB2.0
  • 4 rear
  • 2 front
  • 2 internal

Graphics

D2264 System Board
Pictures not available at present
Connectors on D2264 System Board
	Pictures not available at present
D2264 Board Layout
Pictures not available at present
BIOS Listing
Phoenix First BIOS Version 5.00 Rel 1.0 <F1> Info -/+ Select item / Change Values F9 Setup Defaults Esc Exit Enter Select Menu / Execute Command F7 Previous Values Main Normal Settings Alternative Settings System Time:   HH:MM:SS   System Date   MM:DD:YY   Diskette A:   1.4M None 360K 1.2M 720K Standard IDE:   CDROM     PIO Mode PIO 4     DMA Mode UDMA 2     Firmware xxxx     Silent Mode Disabled Silent, Medium   Password Status Not Supported     Change Password Press Enter (greyed out)           Native IDE:   Maxtor 6Y080M0 - (TM)     Maximum Capacity 80GB     PIO Mode PIO 4     DMA Mode UDMA 6     Firmware xxxx     Silent Mode Disabled Silent,, Medium   Password Status Not Installed     Change Password Press Enter (greyed out)           Boot Options: POST Errors Halt On All Errors No Halt On Any Errors   Fast Boot Enabled Disabled   Quiet Boot Enabled Disabled   Default Primary VGA PEG PCI   Video Memory Size 32MB 64, 128MB   Boot Menu Enabled Disabled   PC Beep Volume HIgh Low, Off Boot Sequence   CD-ROM Drive       Diskette       Hard Drive       Legacy LAN Card       BootManage PXE, Slot 0048   Base Memory   640k   Extended Memory   502m   Advanced Normal Settings Alternative Settings Peripheral Configuration:       Serial 1 Auto Enabled Disabled   Serial 2 Auto Enabled Disabled   Parallel Auto Enabled Disabled   Parallel Mode ECP Printer, Bi Directional, EPP   USB Enable Ports All None, Internal   USB 2.0 Host Controller Enabled Disabled   USB BIOS Supported Devices Auto None, Keyboard/Mouse, All   USB Boot Delay 0's 3,6,9's   USB at Power Off Always On Always Off   ATA Controller Configuration:       SATA Mode Native Compatible, RAID, Auto Detect   Primary IDE Channel Enabled Disabled   Secondary IDE Channel Enabled Disabled   Tertiary IDE Channel Enabled Disabled   Quaternary IDE Channel Enabled Disabled   Diskette Controller Enabled Disabled   Mouse Controller Auto Detect Disabled Enabled   LAN Controller Enabled Disabled   LAN Remote Boot Enabled Disabled   Audio Controller Auto Disabled Enabled         PCI Configuration PCI IRQ Line 1: Auto Disabled IRQ 3 IRQ 4 IRQ 5 IRQ 6 IRQ 7 IRQ 9 IRQ 10 IRQ 11 IRQ 12 IRQ 14 IRQ 15   PCI IRQ Line 2: Auto   PCI IRQ Line 3: Auto   PCI IRQ Line 4: Auto   PCI IRQ Line 5: Auto   PCI IRQ Line 6: Auto   PCI IRQ Line 7: Auto   PCI IRQ Line 8: Auto Advanced System Configuration Graphics Aperture 64M 4,8,16,32,64,128,256   BIOS workspace location Top of base memory Expansion ROM area   SMART Device Monitoring Enabled Disabled   Fan Control Enabled (fan controlled by CPU temp) Disabled Security Normal Settings Alternative Settings Setup Password Not installed   System Password Not installed   Set setup password Press enter   Setup password lock Standard Extended Set system password Press enter   System password mode System keyboard System password lock WOL Skip     SmartCard SystemLock     Memorybird System Lock Disabled Enabled System load Standard Diskette / CD rom lock Setup prompt Enabled Disabled Virus warning Disabled Enabled   Diskette write Enabled Disabled   Flash write Enabled Disabled   ATA Vulnerability Protection Standard Enhanced   Cabinet Monitoring Disabled Enabled   Power Normal Settings Alternative Settings ACPI Configuration:     ACPI Save to RAM Enabled Disabled Safe Standby Disabled Enabled Power On/Off:     Power-on Source: BIOS Controlled ACPI Controlled LAN Enabled Disabled Wake up on LAN Boot Boot Sequence Force LAN Boot Wakeup Timer Disabled Enabled Wakeup Time hh:mm:ss   Wakeup Mode Daily   USB Keyboard Enabled Disabled Power-off Source:     Software Enabled Disabled Keyboard Disabled Enabled Power button Enabled Disabled Power Failure Recovery Previous State Always Off, Always On, Disabled Exit Save Changes and Exit Discard Changes and Exit Get Default Values Load Previous Values